De Tomaso Mangusta

Vehicle Overview

The De Tomaso Mangusta replaced the Vallelunga model, on which its chassis was based. The word “mangusta” is Italian for “mongoose”, an animal that can kill cobras. It was rumored that the car was so named in retaliation to a failed deal between De Tomaso and Carroll Shelby. Alejandro de Tomaso offered to help Carroll Shelby to build a new CanAm race car at the end of 1964 when Shelby found that the Shelby Cobra would not be able to compete there. DeTomaso was planning to develop a new 7.0-litre V8 engine for racing so he saw this as a perfect opportunity. Shelby agreed to finance the project and also sent a SCCA approved design team headed by Peter Brock to Italy in order to handle the design work. De Tomaso had conflicts on the design of the car. He also failed to deliver the agreed 5 race cars within the deadline for the 1965 CanAm season. This caused Shelby to eventually back out of the project and join the development team of the Ford GT40. Peter Brock and his team were able to finish the car according to their will. De Tomaso engaged Carroziera Ghia to finalise the design of the car which was being developed under the project name of P70. The single completed car was displayed at the 1965 Turin Motor Show as the Ghia De Tomaso Sport 5000. De Tomaso then modified the steel backbone chassis of the P70 and it became the basis for the Mangusta, which was designed by Giorgetto Giugiaro at Ghia. The Mangusta entered production in 1967, at the same time De Tomaso had purchased Ghia.

401 cars in total were built, about 150 were made for Europe, while the remainder were made for North America. The initial cars are claimed to have a more powerful Ford HiPo 289 engine; the later cars all had Ford 302 engines. The Mangusta was imported into the United States via a federal waiver which applied to the car due to its small production numbers. The waiver exempted the car from safety regulations which were in effect in the time as the Mangusta came without seat belts and had headlights far lower than what the federal regulations allowed. When this exemption expired, the front of the car was redesigned in order to accommodate two pop-up headlamps instead of the quad round headlamps present earlier. These new headlamps functioned through a crude lever-and-cable arrangement, which fed into the cabin. An estimated 50 cars were produced in this configuration. One car was built with a Chevrolet engine for General Motors-Vice President, Bill Mitchell.

Photo courtesy of Artcurial.